Filter
Top Products
L2170pr-0920
11
L2170pr-0920
11
• First, insert a screw through each side of the vehicle and into the
ends of the windshield/dashboard. Tighten the screws.
• Next, insert two screws through the inside of the vehicle and into
the windshield/dashboard. Tighten the screws.
• Using safety scissors, carefully cut the plastic tie holding the shovel
and clip together.
Note to Retailer: Do not cut the plastic tie. The plastic tie holds the
shovel in place for display purposes.
• Place the clip and shovel assembly onto the hood.
• First, slide a washer onto the remaining screws. Then, insert the
four screws with washers through the underside of the hood and
into the clip. Tighten the screws.
11
• Lift and lower the hood closed.
• Pull the hood strap down and over the button on each side of the
front end of the vehicle.
• Position the steering wheel assembly so that the flat side of the
steering wheel is down.
• Fit the steering column down through the hole in the dashboard
and then out through the hole in the floor of the vehicle.
Hint: You may need to turn the steering column to clear the
windshield and to fit it through both openings.
DASH VIEW
Clip
Shovel
Hood
Hood
Flat Side of Steering Wheel
Steering Column
Screws
Screws
FRONT VIEW
SIDE VIEW
SIDE VIEW
Screws
Washers
12
Button
10
13
Hood Strap