Filter
Top Products
8
Children can be harmed by small parts,
sharp edges and sharp points in the vehicle's
unassembled state, or by electrical items.
Care should be taken in unpacking and
assembly of the vehicle. Children should not
handle parts, including the battery, or help in
assembly of the vehicle.
WARNING
ASSEMBLY
BATTERY CHARGING
E
H4807pr-0922
Dash
• Position the dash on the vehicle.
• Make sure the motor harness connector wire is through the groove
in the dash.
• Insert a #10 x
1
/2
"
screw through each of the two corner dash tabs
nearest to the passenger compartment
A
.
• Insert a #10 x 1" screw through the two dash tabs nearest to the
battery compartment
B
.
• Insert a #10 x 1" screw into the hole in the center of the dash
B
.
• Tighten the screws.
Motor
Harness
Connector
Wire
1
B
A
A
B
B
A B
F
Charger
Connector
• Plug the charger connector into the battery
A
.
• Plug the charger into a standard wall outlet
B
.
Notes:
- Use the charger only in a wall outlet. Do not plug the charger
into a ceiling outlet.
- If power flow to the wall outlet is controlled by a switch, make
sure the switch is “ON”.
- The power indicator on the charger does not indicate the
charge status of your battery. The power indicator allows you
to see that there is power from the wall outlet to the charger.
• Before first-time use, charge the battery for at least 18 hours.
Never charge the battery longer than 30 hours.
• Recharge the battery for at least 14 hours after each use of
your vehicle. Do not charge the battery longer than 30 hours.
• Once the battery is charged, pull firmly on the charger
connector to disconnect it from the battery. Unplug the
charger from the wall outlet. The battery is now ready to be
installed in your vehicle. Please see the Battery Installation
section on page 18 for detailed instructions on installing your
battery. If your battery is already installed in your vehicle,
simply re-connect the motor harness connector to the battery.
Lower and fasten the hood.
A
B
Battery
Power
Indicator