Filter
Top Products
H4807pr-0922
10
ASSEMBLY
F
H4807pr-0922
8
• Turn the vehicle on its side.
• Insert the end of the steering column through the hole in the
steering rod.
• Place a
3
/
8
"
washer on the end of the steering column.
End of
Steering
Column
Steering
Rod Hole
Washer
9
• Insert a #8 x
5
/
8
"
screw through the hole in the end of the
steering column.
• Fit a #8 lock nut on the end of the screw and tighten.
• While holding the lock nut with an adjustable wrench (or
pliers), tighten the screw.
• Turn the vehicle upright.
End of
Steering
Column
#8 Lock Nut
#8 x
5
/
8
"
Screw
• Fit the steering wheel cap into the center of the steering wheel.
• Insert two #8 x 1" screws and tighten.
• Insert the
5
/
32
" x 1
1
/
2
" pin through the hole in the end of the
steering column.
• Lower the steering column so that the pin fits inside the center
of the steering wheel.
6
End of
Steering
Column
5
/
32
" x 1
1
/
2
" Pin
7
Steering
Wheel
Cap
Lens
Wide
Notch
Lens Guard Wide Tab
• Fit the wide notch in the side of a headlight lens under the
wide tab on a lens guard.
• Press firmly on the inside of the headlight lens to snap it into
the lens guard.
• Repeat this procedure to assemble the other headlight lens to
the remaining lens guard.
10
Bottom View