Filter
Top Products
®
®
24
IMPORTANT! Use only a Power Wheels
®
Type H 6 volt battery
with a Power Wheels
®
25 Amp fuse installed. Use of any other
battery or fuse will damage your vehicle. Make sure that you
charge the battery for at least 18 hours using the enclosed
Power Wheels
®
6 volt charger before operating your vehicle for
the first time. Charge the battery for at least 14 hours after each
use of the vehicle. Never charge the battery longer than 30
hours. Failure to follow these instructions may damage your
battery and will void your warranty.
• While pressing the vehicle body tab,
lift the edge of the battery clamp.
• Place a Power Wheels
®
6 volt battery
upright in the battery compartment,
as shown.
Battery Installation
Battery
Battery
Compartment
3
• Rotate the battery clamp down until it "snaps" into place.
Pull up on the battery clamp to be sure it is secure.
Battery
Clamp
4
H
• Lift the seat to remove it from the vehicle body.
• Locate the lock fasteners in the back of the seat.
• Using a slotted screwdriver, turn each lock fastener
1
/
4
turn to the unlocked position.
Locked
Unlocked
Seat
1
2
Lock
Fasteners
Battery
Clamp
Seat
®
See
Inset
Battery
Clamp
C3491pr-0920.qrk 10/30/03 4:01 PM Page 24