Filter
Top Products
14
Assembly
Cab
Hole
Antenna
• Fit the tapered end of the antenna into the hole in the
front of the cab.
• Press firmly to snap the antenna into the hole.
End T-Loop
Seat
Short Seat
Belt Strap
Fastener
• Position the seat upside down.
• Insert the fastener end of a short seat belt strap through
one of the the slots near the outer edge of the seat.
Make sure the side of the seat belt with the fastener
faces the outer edge of the seat.
• Pull the short seat belt strap completely through the slot
until the end T-loop at the opposite end of the belt
catches against the slot. (You will pull one T-loop
through the slot.)
• Repeat this procedure to assemble the other short seat
belt strap to the seat.
Battery
Compartment
Holes
Round Snaps
Hood
• Lower the hood, making sure to align the round snaps
on the underside of the hood with the holes near the
battery compartment.
• Press firmly on the top of the hood above each snap
to fasten the hood. (To open the hood, please see the
instructions on page 18, step 1.)
• Remove the backing from the wire clip. Dispose of the
backing properly.
• Press the wire clip into place in the battery compartment,
as shown.
• Fit the motor harness wires into the wire clip, as shown.
Battery
Compartment
Wire Clip
Wire Clip
Motor
Harness
Wires
21
22
23
20