Filter
Top Products
14
Calibrating the Stylus
• Turn Pixter
TM
over and locate the calibration hole.
• Insert, push and hold the stylus in the calibration hole.Turn Pixter over
so that you can see the screen.When you see two ,you can remove the
stylus from the calibration hole.
• First touch the upper right corner with the tip of the stylus.
• Then, touch the lower left corner with the tip of the stylus.
™
IMPORTANT!
From time to time, the mark made
on your screen from the stylus and
the location of the tip of the stylus
may not align. When this happens,
you must calibrate the stylus.
Mark on Screen
Tip of
Stylus