Filter
Top Products
Handgrip
Handgrip
Handlebar
• Position the handlebar upright.
• Fit a handgrip onto each end of the handlebar.
Hint: If the handgrips are difficult to slide onto the handle-
bar, moisten the handgrips with warm water before fitting
them onto the handlebar.
• Slide a round bushing onto the front axle and press it into
the center of the front wheel.
• Fit a cap nut onto the end of the front axle.
• Tap the cap nut with a hammer to secure it on the
front axle.
• Repeat assembly steps 4 and 5 to assemble the other
front wheel to the other side of the front axle.
Cap
Nut
Front Axle
Round
Bushing
• Insert the connector end of the handlebar wire harness
into the rectangular opening in the handlebar.
• Feed the handlebar wire harness through the handlebar.
• Push firmly on the button end of the handlebar wire har-
ness to snap it into the rectangular opening.
Rectangular
Opening
Handlebar
Button End
Connector
End
Handlebar
Wire Harness
Handlebar
Wire Harness
Handlebar
• Turn the handlebar upside down.
• Align the handlebar wire harness with the guides on the
underside of the handlebar.
• Push firmly on the handlebar wire harness near each
of the guides to secure the wire in the underside
of the handlebar.
Guides
Assembly
9
8
6
5
7