Filter
Top Products
14
Assembly
• Turn the vehicle on its side.
• Fit a traction band around a wheel.
• Slide a slotted screwdriver under the traction band to
push the traction band onto the ridge in the center of
the wheel.
Hint: If the traction band is difficult to fit around the wheel,
you may want to soak it in warm water to soften it slightly.
• Repeat this procedure to assemble a traction band to
each wheel.
• Turn the vehicle upright.
Traction
Band
Wheel
Ridge
24
•“Snap” the center of the spark plug wire set onto the
battery clamp (engine cover).
• Fit each of the spark plug wire ends into the holes on
the sides of the battery clamp (engine cover).
IMPORTANT! You must install your Power Wheels
®
battery in your vehicle before assembling the battery
clamp (engine cover) under the hood. Please refer to
“Battery Installation” on page 16 for detailed instructions.
Spark Plug
Wire Set
Spark Plug
Wire End
Hole
Battery Clamp
(Engine Cover)
25
Bottom View