Filter
Top Products
Set the car and transmitter Power Switches to “On.” The car is ready for
use. Use the transmitter’s control levers to steer the car. (See diagrams
on next page).
Trim Switch Control:
The switch is located on the underside of the vehicle between the two
front wheels and is used to align the wheels for consistent straight-line
driving. (See diagram below).
Trouble Shooting:
IF THE VEHICLE DOES NOT MOVE:
• Are the vehicle and transmitter Power Switches set to “On”?
• Is the vehicle too far away from the transmitter?
• Is the metal tab in the battery cartridge flattened so it doesn’t touch
the tip of the battery?
IF THE VEHICLE DRIVES SLOWLY:
• Are the batteries exhausted?
IF YOU EXPERIENCE POOR RANGE CONTROL:
• Is the battery in the transmitter exhausted?
• Is there strong interference in the area from CB radios or other inter-
ferences?
WARNING:
Changes or modifications to this unit not expressly approved by the
76