Filter
Top Products
8 9
SPECIAL CARE & HANDLING
• Avoid rough handling such as bumping or dropping.
• Avoid moisture and extreme temperatures. For best results,
use between the temperatures of 39º F and 100º F
(4º C and 38º C).
• Never drive your Beverage Buggy on a wet floor, on sand, or
in mud, rain or snow.
• Be sure to remove the batteries from your Corona Beer Buggy
and transmitter when storing the product.
• To protect your Beverage Buggy’s wheel mechanism from
lint, thread, hair and dust particles, you can use a small brush,
tweezers or tie a small bit of cloth to the tip of a toothpick,
etc., and wipe it off.
• Always keep your Beverage Buggy clean. Use a dampened
cloth to wipe off, and then wipe all the water off with a dry
cloth. Never use chemicals to clean the product.
• Avoid holding the wheels when rotating. Holding them will
cause the electronic components to short-circuit, overheat and
cause malfunction.
INSTALLING BATTERIES
To install batteries in the transmitter, please follow the following
steps:
1. Remove the battery cover located on the back.
2. Install one 9-volt battery making sure to match the polarity
(+ and -) with the diagram inside the battery compartment.
3. Replace the battery cover.
To install batteries in your Beverage Buggy, please follow the
following steps:
1. Open the battery compartment located on the underside of the
vehicle by turning the lock and lifting the cover off.
2. Install four AA batteries making sure to match the polarity (+
and -) with the diagram inside the battery compartment.
3. Replace the cover of the battery pack and lock the cover.
(Also see Battery
Information on page 10.)
Changes or modifications to this unit not expressly
approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
Your Beverage Buggy uses a
frequency of 49 Mhz.
ENGLISH
ENGLISH