Filter
Top Products
Mounting the Engine
All model airplanes include an engine mount of some
type. It is extremely important that the engine be securely
mounted to the airplane’s engine mount. Follow the
instructions included with the airplane for mounting
the engine.
Important: Before each flying session, check that all
engine mounting screws are securely tightened.
Included Items
Engine
Muffler (standard) EVO036601
Muffler (Tongue) EVO036601L
Muffler Screw Gasket Set EVO036E36A,
Glow Plug EVOGP1
Wrench
Instructions
Decal Sheet
Optional Items
Glow Plug (2 & 4 Cycle) EVOGP1
Glow Plug Wrench HAN2510
Manual Fuel Pump HAN118
Blue Block After Run Oil EVOX1000
Metered Glow Driver with Nicad HAN7101
Power Pro 12V Starter HAN161
Fieldmate Prebuilt Flight Box HAN117
Installing the Muffler
Using the included muffler mounting screws and lock
washers, attach your choice muffler with the included
hex wrench. Be sure the lock washers are placed over the
screws and that one gasket is placed between the muffler
and the engine. A second gasket is included as a spare.
Securely tighten both screws with moderate torque. The
exhaust outlet of the muffler can be rotated to allow the
exhaust outlet to be repositioned for various applications.
1. Loosen the lock nut on the back of the muffler and then
loosen the assembly screw.
2. Rotate the rear half of the muffler to the desired
position.
3. Tighten the assembly screw first and then tighten the
lock nut.
Important: After five runs, retighten the muffler
mounting screws and head bolt. Heat and vibration from
these first few runs can cause the gasket to compress.
Once the muffler screws are re-tightened, they will
remain tight and leak-free until the muffler is removed.
Also, if you have chosen the tube style muffler, tighten the
muffler thru-bolt at this time as well—loosen the lock
nut on the back of the muffler, tighten the thru-bolt via
the screwhead at the front of the muffler then retighten
the lock nut at the rear.
3
Securely tighten all engine mounting screws and re-check tightness
before each flying session.
The muffler mounting accessory package includes mounting screws
(2), lock washers (2), muffler gaskets (2) and an L- wrench.
High-Speed Needle