Edelbrock 97386 Automobile Parts User Manual


  Open as PDF
of 2
 
©2009 Edelbrock Corporation
Brochure #63-0272
Catalog #97383, 97384, 97385, 97386, 97387, 97443, 97453
Rev. 7/09 - AJ/mc Page 2 of 2
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503
Tech Line: 800-416-8628
®
LIFTER INSTALLATION KIT: INSTALLATION PROCEDURE
1. If using lifter installation kit 97386 or 97387, install the lifters using
the supplied lifter guides to line up the lifters.
2. Install the lifter hold down spider over the lifter guides. Make sure
each tab on the spider contacts the center of each lifter guide.
3. Secure the lifter hold down spider to the lifter valley using the three
supplied hold down bolts. Torque bolts to 18 ft./lbs.
4. Adjust lifter preload as described in the “Installation Notes” section
on Page 1.
Figure 1 - Lifter Installation Kit, Installed
IMPORTANT NOTE REGARDING RETRO-FIT LIFTER INSTALLATION:
When installing retro-fit lifters that use a tie-bar, it is critical that the arrow on
the tie-bar point up towards the intake manifold when the lifters are installed. This should orient the Edelbrock logo on the tie-bar so that it can be
read right-side up. Failure to orient the lifters properly can cause damage to the camshaft and other engine components.
 previous