Filter
Top Products
©2007 Edelbrock Corporation
Catalog #65232 & #65233
Page 2 of 2
Brochure #63-65232
Rev. 2/07 - DA/mc
RIGHT SIDE
1. Remove nuts and studs, then remove stock manifold
and gasket from vehicle. Loosen the motor mount
bolts and slightly raise the right side of the engine
just enough to remove the manifold down and
around the motor mount.
2. Install port flange gasket and 8mm bolts, lock
washers, and flat washers in the front two upper and
rear two lower bolt holes. Leave bolt loose enough
to accept header.
3. Place header into position, install using supplied
bolts, lockwashers and hardened washers. Tighten
evenly. NOTE: Use anti-seize compound on all bolts.
FINAL ASSEMBLY
1. Re-install starter.
2. Lower engine and tighten motor mount bolts.
3. With collector donuts on headers, re-connect exhaust
pipes to headers using supplied bolts and lock
washers.
4. Re-connect battery.
5. Start vehicle and bring up to normal temperature.
Check for possible leaks.
6. Turn engine off and let cool. Re-tighten all bolts.
7. Re-install fender wells.
8. Re-install front tires if removed. Be sure to torque
lug nuts to factory specifications.
Edelbrock Corporation
2700 California Street
Torrance, CA 90503
Toll-Free Tech Line: 1-800-416-8628
Tech E-Mail: Edelbrock@Edelbrock.com
Qty. Part # Description
1 25-9800 Manifold Left Side (#65232)
1 25-9801 Manifold Right Side (#65232)
1 25-9802 Manifold Left Side (#65233)
1 25-9803 Manifold Right Side (#65233)
2 - Port Gaskets
2 - Donut Gaskets; 2-1/2” Diameter
16 - Header Bolts; 8mm x 1.25” x 30mm
16 - Lockwashers; 5/16”
16 - Hardened Washers, Black; 5/16” I.D. x 1/8” O.D.
4 - Hex Bolts; 3/8” - 16 x 2”
4 - Lockwashers; 3/8”
PARTS LIST
Catalog #65232 (Ceramic-Coated)
Catalog #65233 (Ti-Tech Coated)