Edelbrock 6510 Automobile Parts User Manual


  Open as PDF
of 2
 
©2000 Edelbrock Corporation
Rev. 4/27/00
Catalog #6510
Page 2 of 2
Left Side
1. Disconnect spark plug wires from spark plugs.
2. Disconnect E.G.R. tube from rear of manifold.
(Stock E.G.R. adapter fitting will be re-used.)
3. Disconnect temperature sensor wire.
4. Unbolt and remove manifold from top side.
5. Install flange gasket and one 3/8"-16 x 1" bolt,
lock washer, and flat washer at rearmost bolt
hole (leave bolt loose enough to accept Header).
6. Install left side Header from top side.
7. Install all bolts and washers on left side (do not
tighten at this time).
NOTE: Thick washers are to be used on slotted
holes of port flange.
8. Re-install E.G.R. tube to header using stock
adapter.
9. Align all parts and tighten left side flange bolts at
this time.
10. Re-install spark plug wires.
11. Re-install temperature sensor wire to
temperature sensor.
ASSEMBLY OF EXHAUST PIPE
1. Using supplied hardware and new donut gaskets
on both sides, re-attach the factory extension
pipes to the headers, and tighten bolts evenly to
ensure a tight seal.
2. Re-connect O2 sensors. Route O2 sensor wire
from loom to O2 sensors away from exhaust
components.
FINAL INSPECTION
1. Check all lines (hydraulic, vacuum, air
conditioning and fuel) to ensure there is
adequate clearance to headers.
2. Re-connect battery.
3. At this point, it is a good idea to look everything
over and make sure that nothing was missed in
assembly.
4. Start vehicle and bring up to normal operating
temperature. Check for possible leaks.
5. Turn engine off and let cool. Tighten all bolts
again.
HARDWARE SUPPLIED
Qty. Description Qty. Description
❑ 1 #25-9157 Header left side ❑ 6 3/8” Flat washers
❑ 1 #25-9158 Header right side ❑ 1 1/4 Hex capscrew
❑ 12 Hex header bolts ❑ 4 Hardened washers (for header flange slotted holes)
❑ 2 Port gaskets ❑ 6 3/8” Hex nuts
❑ 2 Donut gaskets ❑ 1 3/8” O.D. spacer
❑ 6 3/8” Hex capscrews ❑ 3 Wire ties
❑ 18 3/8” Lock washers
Edelbrock Corporation
2700 California St.
Torrance, CA 90503
Tech Line: (800) 416-8628
Office: (310) 781-2222
E-Mail: edelbrock@edelbrock.com
 previous