Edelbrock 65012 Automobile Parts User Manual


  Open as PDF
of 2
 
©2005 Edelbrock Corporation
Catalog #65012 & #65013
Page 2 of 2 Rev. 1/05
DA/mc
Edelbrock Corporation, 2700 California St., Torrance, CA 90503
Tech Line: 1-800-416-8628
Office: 310-781-2222
Tech Fax: 310-972-2730
E-Mail: edelbrock@edelbrock.com
1. On 4.8L & 5.3L V8s - Remove the donut gasket from
right side exhaust manifold. Using a pair of pliers,
remove the retaining ring from the donut gasket and
place the donut gasket in flare of factory exhaust pipe.
2. Using supplied hardware, re-attach the factory exhaust
pipes to the headers and tighten bolts evenly to ensure
a tight seal. (Note: The 7/16 x 2 bolts are to be used on
the right side of 4.8L & 5.3L V8s and the 7/16 x 1 ¾ are
for the left side of 4.8L & 5.3L V8s, or both sides on 6.0L
V8).
FINAL INSPECTION
1. Check all lines (hydraulic, vacuum, air conditioning and
fuel) to ensure there is adequate clearance to headers.
2. Re-connect battery.
3. At this point, it is a good idea to look everything over and
make sure that nothing was missed in assembly.
4. Start vehicle and bring up to normal operating
temperature. Check for possible leaks.
5. Turn engine off and let cool. Tighten all bolts again.
PARTS LIST
Part #65013 (Ti-Tech-Coated)
Qty. Part # Description Qty. Part # Description
1 25-9227 Manifold left side 6 - 7/16” Lock washers
1 25-9228 Manifold right side 6 - 7/16” Hex nuts
4 - Hex header bolts; 8mm x 1.25 x 30mm 6 - 7/16” Flat washers
8 - Hex header bolts; 8mm x 1.25 x 25mm 1 - EGR gasket
2 - Port gaskets 14 - 5/16” Lock washers (Header flange)
6 - 7/16” x 1-3/4 Hex bolts 4 - Hardened washers (for header flange)
3 - 7/16” x 2 Hex bolts slotted holes
2 - Exhaust crush rings 2 - A.I.R. Flange gaskets
Part #65012 (Ceramic-Coated)
Qty. Part # Description Qty. Part # Description
1 25-9249 Manifold left side 6 - 7/16” Lock washers
1 25-9250 Manifold right side 6 - 7/16” Hex nuts
4 - Hex header bolts; 8mm x 1.25 x 30mm 6 - 7/16” Flat washers
8 - Hex header bolts; 8mm x 1.25 x 25mm 1 - EGR gasket
2 - Port gaskets 14 - 5/16” Lock washers (Header flange)
6 - 7/16” x 1-3/4 Hex bolts 4 - Hardened washers (for header flange)
3 - 7/16” x 2 Hex bolts slotted holes
2 - Exhaust crush rings 2 - A.I.R. Flange gaskets
 previous