Filter
Top Products
©2006 Edelbrock Corporation
Brochure #63-1602Page 6 of 6
Catalog #1602, 1615
Rev. 4/06 - RS/mc
CAUTION
Do not turn engine over until push rods spin freely.
Damage could occur to valves.
NOTE: If the original push rods are being installed, be sure
you do not turn them end for end from their original position
because they have worn into their mating components.
4. Install the middle (4) and top (3) rocker arm covers, using new
gaskets and new fiber seals. The fiber seals must be under the steel
washers. Be sure the middle cover section is spaced evenly on all
sides before tightening the cover screws. Tighten the screws to 10-
13 ft./lbs. following a crisscross pattern. If a torque wrench cannot
be used, tighten securely by hand.
5. Install intake manifold according to the instructions provided with
the Edelbrock intake manifold.
6. Install the carburetor, V.O.E.S. and ignition components.
7. Reassemble all components removed during disassembly, connect
battery cables, and re-fuel gasoline tank.
8. To prevent discoloration when the engine reaches operating
temperature, carefully wipe off grease, fingerprints, stains, etc. from
all chrome and polished surfaces with a lint-free cloth and alcohol,
Windex, etc., before starting engine.
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503
Tech-Line: 1-800-416-8628 • E-Mail: Edelbrock@Edelbrock.com
Figure 11 - Rocker Arm Shaft Bolt Notches
REPLACEMENT ITEMS
The following replacement items are available separately:
Exhaust Seat . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .#1643
Intake Seat . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .#1644
Exhaust Valve . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .#1645
Intake Valve . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .#1646
Exhaust Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .#1647
Intake Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .#1648