Filter
Top Products
INSTALLATION
Where space contraints prevent installing the breather in vent
locations 5 for Position E or location 6 for Position F (see Figure
1), install vertical breather kit in location 2 for Position E or location
4 for Position F.
Figure 1–Reducer Mounting Positions
Table 1 - Parts for Vertical Breather Kit
Table 1–Parts for Vertical Breather Kit
Figure 2 – Vertical Breather Kit Assembly
Refer to Table 1 for Dodge replacement part numbers and
pardescriptions.
Refer to Table 1 for Dodge replacement part numbers
and part descriptions.
* Refer to Figure 2.
** Two lengths of pipe nipple are provided. Only one is required. Use length best suited to application and discard the other.
*** Not shown. This part is used only on TA4 – TA12 reducers to adapt 3/4 NPT hole to 1/2 pipe nipple.
Qty.
Ref. No* Part Description Part No.
TA0–TA3 (900112) TA4–TA12 (904112)
1 Air Vent Assembly TAO - TA3 241237 1 ---
Air Vent Assembly TA4 TA12 245237 --- 1
2 3/8 Pipe Coupling A31484 1 ---
1/2 Pipe Coupling A45622 --- 1
3 3/8 x 90°Street Ell A38815 1 ---
1/2 x 90° Street Ell A38817 --- 1
4** 3/8 x 1 1/2 Pipe Nipple A38847 1 ---
1/2 x 1 1/2 Pipe Nipple A38845 --- 1
5** 3/8 x 3 Pipe Nipple A31570 1 ---
1/2 x 3 Pipe Nipple 304596 --- 1
6*** 3/4 x 1/2 Hex Bushing 430079 --- 1
WARNING: To ensure that drive is not unexpectedly started,
turn off and lock out or tag power source before proceeding.
Remove all external loads from drive before removing or
servicing drive or accessories. Failure to observe these
precautions could result in bodil
y
in
j
ur
y
.