Dodge 2010 Viper SRT10 Automobile User Manual


 
At Each Stop for Fuel
Check the engine oil level about five minutes after a
fully warmed engine is shut off. Checking the oil level
while the vehicle is on level ground will improve the
accuracy of the oil level reading. Add oil only when
the level is at or below the ADD or MIN mark.
Check the windshield washer solvent and add if
required.
Once a Month
Check tire pressure and look for unusual wear or
damage.
Inspect the battery, and clean and tighten the terminals
as required.
Check the fluid levels of the coolant reservoir, brake
master cylinder, power steering, and transmission,
and add as needed.
Check all lights and all other electrical items for correct
operation.
At Each Oil Change
Change the engine oil filter.
Inspect the exhaust system.
NOTE: Also, inspect the exhaust system if you notice a
change in the sound of the exhaust system, or if the
exhaust fumes can be detected inside the vehicle.
Inspect the brake hoses.
Inspect the suspension components.
Lubricate door hinges and check springs.
Check the engine coolant level, hoses, and clamps.
Check power steering fluid level.
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S
268 MAINTENANCE SCHEDULES