Filter
Top Products
25% or more below the light load inflation pressure (cold)
tire pressure values. The light load inflation pressure
(cold) tire pressure values are defined in the Supplemen-
tal Tire Pressure Information label located on the rear face
of the driver door. If the switch LED did not turn ON,
you may need to drive the vehicle for one minute above
15 mph (25 km/h) and then press the “Light Load” reset
switch again. Also, the TPM system low pressure telltale
lamp will turn off once the vehicle has been driven for up
to one minute above 15 mph (25 km/h). The TPM system
will now remain in the Light Load vehicle pressure
monitoring condition and the “Light Load” reset switch
LED will remain ON for each subsequent key cycle,
unless the system experiences a loss of electrical power as
previously described.
If the “Light Load” reset switch amber colored LED
flashes on and off for 10 seconds, after all four tire
pressures have been lowered to the Light Load inflation
pressures, the pressure in any one of the four tires may
not be at the light load inflation pressure (cold) values as
indicated for the Light Load condition as defined in the
Supplemental Tire Pressure Information label located on
the rear face of the driver door. Using an accurate tire
pressure gauge, re-check the tire pressures for the light
load inflation pressure (cold) value and drive the vehicle
for up to one minute above 15 mph (25 km/h) and press
the “Light Load” reset switch again.
STARTING AND OPERATING 353
5