5
TABLE OF COMMANDS
COMMAND
B
UTTONS
C
ONFIRMATIONS
HORN PARKING LIGHTS
SIREN*
GROUPE 1 GROUPE 2
PANIC
OR
(> 4 SEC.)
AND
(> 4 SEC.)
30 / 60 SEC.
START / CONTINUOUS MODE
1 1 -
STOP
(> 4 SEC.)
1 1 -
LOCK / ARMING*
(REDUCED RANGE IF < 2 SEC.)
1 1 / 3
1
/ 3 / X
UNLOCK / DISARMING*
(REDUCED RANGE IF < 2 SEC.)
- 2 / 4 ¡
2
/ 4 / X
¡
TRUNK 1
- 1 / 3 3
ACTIVATE / DEACTIVATE SENTINEL MODE
- 4 / 2 / 3 ¢ -
CAR FINDER
7 3 -
RUNTIME SETTING
-
1 – 4 -
DISPLAY REMOTE START FAIL CODES
- 1 - 20 -
ACTIVATE / DEACTIVATE UTILITY 1
(> 4 SEC.)
- 1 -
ACTIVATE / DEACTIVATE UTILITY 2
(> 4 SEC.)
- 1 -
ACTIVATE / DEACTIVATE UTILITY 3
- 1 -
ACTIVATE / DEACTIVATE UTILITY 4
- 1 -
VALET MODE ACTIVATE / DEACTIVATE
- 4 / 2 ¢ -
DISPLAY ALARM CONDITION CODES
- 1 – 8 -
KEYPAD LOCK
- - -
MUTE MODE (REMOTE TRANSMITTER)
- - -
COMMAND GROUPE (TOGGLE)
COMMAND GROUP SELECTING UPON INSTALLING.
G
ROUP 2 USAGE IS PREFERABLE WHEN REMOTE
STARTER IS EQUIPPED WITH A SECURITY SYSTEM
.
* COMMAND RELATED TO ARMING AND DISARMING ONLY APPLIES TO SYSTEM THAT IS INTERFACED WITH AN OPTIONAL SECURITY SYSTEM (ALA-OP).
THIS CONFIRMATION IS SENT ONLY WHEN COMMAND IS REPEATED WHILE ENGINE IS ALREADY RUNNING (HORN: PROGRAMMABLE
DURING INSTALLATION
). THIS COMMAND ENDS: RUNTIME, ALARM CONDITION AND PANIC MODE CONFIRMATION BY CHIRP OR
HORN ON
2ND LOCK (WHEN PROGRAMMED "ON").. ONLY IF SYSTEM IS EQUIPPED WITH A SENSOR, WHICH DETECTS WHEN TRUNK
IS OPEN
(OPTIONAL). THESE CONFIRMATIONS ARE PROGRAMMABLE ENABLE/DISABLE DURING INSTALLATION. 1 = NO ZONE IS
IN VIOLATION AT ARMING
. 3 = AT LEAST ONE ZONE IS IN VIOLATION AT ARMING. X = NO CHIRP WHEN VALET MODE IS ACTIVE OR
WHEN ALARM IS PROGRAMMED
"OFF". TEMPORARY VALET MODE IS DISABLED IF COMMAND IS REPEATED DURING REARMING
CYCLE
. ¡ 2 = NO ZONE WAS IN VIOLATION WHEN ALARM WAS ARMED. 4 = AT LEAST ONE ZONE WAS IN INFRACTION WHEN ALARM
WAS ARMED
. ¢ 4 = ACTIVATED / 2 = DEACTIVATED / 3 = SYSTEM NOT READY. 1 PARKING LIGHTS FLASHES ONCE IF THE COMMAND
CANNOT BE EXECUTED
.
CONFIRMATION
In all cases, your Remote Starter will confirm that command has been received properly.
This will be done by either sounding horn or flashing parking lights. In this manual, confirmation signals are written in an
abbreviated form; for example: (horn: 1, lights: 2) Means that horn will sound once and parking lights will flash twice.
Parking light confirmations are mandatory. Horn confirmations are optional (programmable) and require an additional
connection and equipment during installation.
Confirmations are explained in more detail under each command.