Filter
Top Products
17
©
1999 Directed Electronics, Inc.
To shut down the remote start:
1. Disarm the security system (if
armed) by pressing on the
transmitter.
2. Enter the vehicle and turn the
ignition to the ON position.
3. Step on the brake pedal.
The remote start system will be shut down when you step on the
brake pedal. The vehicle motor, however, will continue to run
because the ignition has been turned on. The vehicle will now
operate as usual.
A vehicle equipped with the Valet
®
Take-Over system can remain
running after the key is removed from the ignition. This feature is
useful for occasions when you wish to exit the vehicle for short
periods of time, but would like to leave the motor running and the
climate controls on.
To perform Valet
®
Take-Over, before turning off the engine:
1. Press and release and on the transmitter (or press and
release the optional Momentary switch).
2. Turn the ignition key to the OFF position. (The engine will
stay running.)
3. The engine will run until the programmed time elapses or a
shut down input is received.
NOTE: This feature will not work while the brake pedal is being pressed.
Valet Take-Over