Directed Electronics 5101 Automobile Electronics User Manual


 
16
© 2009 Directed Electronics. All rights reserved.
Placing the remote into the remote pair mode:
Press and hold the 1. button for 8 seconds. If the transmit LED flashes at
3 seconds, disregard and continue to hold.
Wait for the Transmit LED to light solid. Release the 2. button.
Press the 3.
AUX
AUX
button for 1 second. The transmit LED flashes 3 times.
Within 5 seconds, press the 4. button.
The vehicle horn honks. You have now successfully learned the remote to 5.
the vehicle remote start system.
To exit remote pairing:
Press and release the • button one time, and then press and hold it for
1.5 seconds. The transmit LED turns off.
Overriding the optional Starter kill
To bypass the optional Starter kill without a remote control:
Use the button on the Control Center (see diagram below) to bypass the
system. You can bypass the system only if you have the vehicle key.
To check proper operation:
While the vehicle is locked, open the door. Immediately insert the key 1.
into the ignition and turn it to the Run or On position. (all the indicators in
the dash turn on)
Press and release the Control button one time. The LED on the Control 2.
Center will stop flashing and the optional Starter kill is bypassed. You
can now start the vehicle with the key.
Note: The override feature allows you to select a specific number of presses
needed to disable the system. If the override button has been programmed to
a new number of presses by your authorized dealer, that number should be
indicated below.
Override button presses ________