Filter
Top Products
7
© 2009 Directed Electronics. All rights reserved.
To perform Valet Take-Over:
Before turning off the engine, press the auxiliary channel on your 1.
Keyless Entry or Security system. (See your authorized Directed
Dealer for the programmed number of times required to activate
remote start.)
Turn the ignition key to the OFF position. (The engine will stay 2.
running.)
The engine will run until the pre-programmed time elapses or a 3.
shut-down input is received. (See page 9 for complete list of shut-
down inputs.)
Note:
This feature will not work if the brake pedal is being pressed.
➢ Starter Anti-Grind Circuitry
Whenever the vehicle is remote started, advanced anti-grind circuitry
prevents the starter from engaging, even if the key is turned to the start
position. This prevents damage to the starter motor if the key is turned to
the start position during remote start operation.
Note:
Anti-grind circuitry only works when the remote start system is
op er at ing the motor and the optional relay is installed.
➢ Disabling the Remote Start system
This feature allows your system's remote start unit to be temporarily
disabled to prevent the vehicle from being remote started accidentally.
This feature is useful if the vehicle is being serviced or stored in an
enclosed area. To disable the remote start, move the shutdown toggle
switch to the OFF position. The switch can be installed in a location of
your choice. Check with your installer for recommended locations.
Location Of Shutdown Switch
_________________________