Directed Electronics 3000 Remote Starter User Manual


 
7
© 2010 Directed Electronics. All rights reserved.
After the remote start module has been installed, contact your autho-
rized dealer to have him or her test the remote start module by perform-
ing the Safety Check outlined in the product installation guide. If the
vehicle starts when performing the Neutral Safety Shutdown Circuit
test, the remote start unit has not been properly installed. The remote
start module must be removed or the installer must properly reinstall the
remote start system so that the vehicle does not start in gear. All installa-
tions must be performed by an authorized Directed dealer.
OPERATION OF THE REMOTE START MODULE IF THE VEHICLE
STARTS IN GEAR IS CONTRARY TO ITS INTENDED MODE OF OP-
ERATION. OPERATING THE REMOTE START SYSTEM UNDER THESE
CONDITIONS MAY RESULT IN PROPERTY DAMAGE OR PERSONAL
INJURY. YOU MUST IMMEDIATELY CEASE THE USE OF THE UNIT
AND SEEK THE ASSISTANCE OF AN AUTHORIZED DIRECTED DEAL-
ER TO REPAIR OR DISCONNECT THE INSTALLED REMOTE START
MODULE. DIRECTED WILL NOT BE HELD RESPONSIBLE OR PAY FOR
INSTALLATION OR REINSTALLATION COSTS.
Caution
This product is designed for fuel injected, automatic transmission ve-
hicles only. Use of this product in a standard transmission vehicle is
dangerous and contrary the product’s intended use.