Filter
Top Products
26
©
1999 Directed Electronics, Inc.
Rapid Resume Logic
This DEI
®
system will store its current state to non-volatile mem-
ory. If power is lost and then reconnected the system will recall
the stored state from memory. This means if the unit is in Valet
®
Mode and the battery is disconnected for any reason, such as ser-
vicing the car, when the battery is reconnected the unit will still
be in Valet
®
Mode. This applies to all states of the system includ-
ing arm, disarm, and Valet
®
Mode.
Power Saver Mode
Your system will automatically enter Power Saver Mode while
armed or in Valet
®
Mode, after a period of time in which no oper-
ation has been performed. This lowers the current draw on the
vehicle's battery and prevents the system from draining the bat-
tery. Power Saver Mode takes over under the following conditions:
■ Power Saver when the system is armed: After the system has
been armed for 24 hours the LED will flash at half its normal
rate, decreasing the system's current draw.
■ Power Saver in Valet
®
Mode: When the system enters Valet
®
Mode the LED illuminates steadily. If the vehicle is not used
(ignition is not turned on) for a one hour period while the