Filter
Top Products
| 98 | DLO TRANSDOCK CLASSIC USER MANUAL
the iPod click wheel, just as you normally would. To adjust the volume of your
iPod audio, use your car stereo’s volume control, not the volume on your iPod.
Your TransDock Classic isusing thesuperior line-outaudio from the bottom of
your iPod, which is not controlled by your iPod click wheel.
Finding Empty Radio Frequencies Using IntelliTune
If you live in a big city with a lot of FM radio stations, finding an empty FM
frequency can be tricky. DLO’s IntelliTune simplifies the process by doing all
the work for you.
To find an empty frequency using IntelliTune:
1. To activate the IntelliTune feature, press TransDock Classic’s side buttons
simultaneously. TransDock Classic’s LCD screen will flash as it searches
for the optimal frequency. This should only take a few seconds.
2. Once the search is complete, TransDock Classic’s LCD screen will display
the optimal frequency in your area. Then, tune your FM radio to that sta-
tion and begin enjoying your iPod music over your car stereo.
Manually Tuning Your TransDock Classic
TransDock Classic also allows you to manually tune the transmitter to your
desired FM frequencies. To tune your TransDock Classic, use the triangular
Tuning Buttons on either side of the LCD screen on the front of TransDock
Classic. Use the right button for tuning up, left button for tuning down.
TransDock Classic has four preset stations. The default frequencies for these
presets are 88.1, 94.9, 100.9, and 107.9. To cycle through these presets, press
the Preset Button on the right side of TransDock Classic. The LCD will show
which preset number you’re writing to, ie. CH01, CH02, etc, andthen the preset
frequency. You can set your own preset when you find frequencies that work
well in your area. To learn how, please read Setting Preset Stations [pg 10].
Tips for manually finding an empty station:
• Be sure to search the entire spectrum of FM frequencies, from 88.1 to
107.9. Don’t just look to the low end of the dial. There are often empty FM
stations in the 100’s that work well.
• When using scan/seek on your car’s radio, if your tuner stops on 101 and
then jumps to 103, look in the 102 frequencies for empty stations.
• Try tuning to a strong station, then backing down two frequencies - for
example 103.5 to 103.1. You can often find empty frequencies this way. If
that frequency is taken, scan to the next station and try again.
NOTE: You can also visit www.dlo.com/openFM to find the best FM
frequencies in your area.