Filter
Top Products
2. Remove one screw from each side, facia to fender.
3. Remove six plastic push fasteners from bottom side of
facia and one screw from each side that attaches to
wheel well extension.
4. Pull facia straight out on each side by fender and carefully
pull facia off.
5. Remove six bolts that hold bumper on, four on the top
side and two underneath. Set bumper aside tempo-
rarily.
6. Remove three bolts that hold windshield washer tank
and also remove bolt that holds horn and let horn hang.
NOTE: The horn bolt will not be reused.
7. Drill out two holes on front of vehicle, one on each side,
with 3/8 drill bit. (See picture)