Filter
Top Products
INSTALLATION INSTRUCTIONS
NOTE: The dimensional variations between otherwise
identical vehicles can be considerable. Some mi-
nor modifi cations may have to be made to ensure
a proper fi t.
1. Loosen all Air Dam/Valance bolts.
2. Pull the Air Dam/Valance towards the front of the vehicle
and insert Frame Nut Strip
3. Install base plate with rear bolts snug so front ears
touch Air dam/Valance.
NOTE: Some bolts may need
to be put back in so it is stable for marking and cutting
of slots.
5. Lower or completely remove base plate. Cut out air
dam\valance slots as earlier marked. Trial fi t the base
plate.
8. Install base plate and nut strip using four 1/2” x 1-1/2”
bolts and 1/2” lockwashers.
NOTE:
R
Blue must be used on all fasteners.
9. Re-Install Air Dam/Valance.
4. Mark the 1-5/8” x 2-1/2” slots by using the pulling ears
of the base plate to guide you in the loacation.
6. Raise base plate and make sure pulling ears clear
Air Dam/Valance slots. Use base plate for template
and mark front holes.
Remove base plate and frame nut
strip.
7. Drill front holes in frame using 9/16” bit. Check existing
frame hole and ream with 9/16” bit if necessary.