Filter
Top Products
Installing the GPS Module
Page 2 GPS Module Installation Manual
Installing the GPS Module
1. Mount the GPS Module under the dashboard of the vehicle.
2. Secure the GPS Module in place using the provided cable ties, velcro tape,
or double-sided tape.
Installing the GPS Antenna
1. Mount the GPS antenna on top of the dashboard, on the roof of the
vehicle, or on the truck.
• Locate the antenna so that it has a clear view of the sky. Any metal
obstructions may interfere with satellite reception.
• The antenna must be at least three (3) feet away from any cellular or
CB antenna. Close proximity to a transmitting antenna may degrade
or disrupt GPS reception.
2. Secure using two screws, double-sided tape, velcro, or magnetic
mounting.
• To use the magnetic mount you must remove the aluminum base
plate to expose the antenna’s neodymium magnets.
3. Route the antenna cable to the GPS Module.
Making Connections
Refer to the installation diagram below to connect your GPS Module.
1. Connect the GPS Antenna to the GPS Module.
2. Connect the GPS Module to the DriveRight harness cable using the
DriveRight 600 adapter cable.
3. Connect the GPS Module to the DriveRight 600.
Note: GPS must be enabled via DriveRight software for the module to function.
Installation Diagram
DriveRight 600
Adapter Cable
GPS Module
DriveRight 600 DisplayGPS Antenna
07395.190 GPS Installation Rev B 6 27 2003.fm Page 2 Friday, June 27, 2003 8:12 AM