Filter
Top Products
13
❏ Log Out
To “log out” press and hold SET/CLEAR for 2 seconds, until
the code resets to 0000. As soon as a driver logs out, the cur-
rent trip is ended and data for that trip stored in the DriveRi-
ght 600’s memory. Note that you may not log out when the
vehicle is in motion.
Two Digital Inputs
Two digital inputs allow you to track the operation of lights or other
electrically powered accessories on the vehicle. A typical application
would be to monitor the headlights and the brakes. The screen dis-
plays “1” if the input is on, and “0” if the input is off. The status of the
inputs is stored in the trip log.
Activity Indicator
Primarily useful for troubleshooting the installation, the small “dot”
between the two activity indicators will appear whenever the reed
switch used with the 8156GD and 8156HD models is closed, or when-
ever the VSS input used with the 8156VSS and 8156VF models is high.
The reed switch closes once each time the vehicles drive shaft rotates.
Trip Start/End Log Screen
The Trip Start/End Log Screen shows the start and end time for each
trip currently stored in the DriveRight 600’s memory. To view trip
times for a specific driver, enter that driver’s ID code in the Driver ID
Code Entry screen. To view all trip times for the vehicle, enter ID code
0000.
NOTE: If the end time for a trip is “dashed,” it means that you are view-
ing the current trip, which has not yet ended (unless the unit was
restarted in the middle of a trip).
Trip Start/End Log Screen
Trip Start Time Date
Trip End Time Trip Duration
E
ND
S
T
AR
T
P
M
P
M
L
OG
T
O
T
A
L
H
r
.
D
A
Y
.
M
O
DR600 UG Rev B D008.fm Page 13 Thursday, April 17, 2003 7:17 AM