Filter
Top Products
18
SETTINGS SCREENS
The following section explains all the information and options avail-
able in the various settings screens. In addition to the options listed
in the individual sections below, in every screen you have the fol-
lowing two options:
❏
Move to the next Settings Screen
Press and release MODE.
❏
View the Data Screens
Press and hold MODE.
Security Code Screen
If you are concerned about unauthorized changing of DriveRight
600 settings, you may enter a security code from the DriveRight or
the software. After you have entered a security code, the DriveRight
600 will not allow access to the rest of the settings screens until the
correct 4-digit security code is entered. The unit allows five attempts
to enter the correct security code before returning to the Current
Readings screen and activating the tamper indicator (pressing
MODE to move to the next settings screen is considered an
“attempt”). The time and date of the unsuccessful tamper attempt is
stored and may be viewed using the DriveRight Vehicle Manage-
ment Software.
NOTE: Use security code 0000 (four zeros) if you do not want to pass-
word-protect calibration, since the unit defaults to that code
when first displaying the Security Code screen.
Security Code Screen
You have the following options from the Security Code Screen:
❏
Enter the Security Code
The flashing digit in the code is the active digit. Press and
release PLUS or MINUS to cycle forward or backward
through the available entries for the active digit (0 to 9). To
change the active digit, press and release SET/CLEAR.
Each time you press SET/CLEAR, the next digit becomes
active. Once the correct security code has been entered,
press MODE to move to the next settings screen.
C
O
D
E
S
E
TT
I
N
G
S
DR600 UG Rev B D008.fm Page 18 Thursday, April 17, 2003 7:17 AM