Filter
Top Products
MAN# 650305:D
SPEEDOMETER SETUP
Press and hold the switch while turning the key on and starting the engine. Once the engine is running, release
the switch. Press and release the switch to change the menu selection.
dIAG
dIAGdIAG
dIAG Diagnostics mode for checking/clearing trouble codes
• Press and release the switch until “dIAG” is displayed, then press and hold the switch until “ - ” is displayed.
• Release the switch. The display will show “ENGINE”, “SECvRE”, ”ABS”, or “DoNE”.
• Press and release the switch to change the selection, press and hold the switch until “ - ” is displayed to begin reading the
stored codes for the particular system.
• Release the switch. The display will show the current codes, “none”, or “no rsp”. Press and release the switch to move to the
next stored code. After all codes are displayed the module part number will be scrolled across the screen. To clear codes,
press and hold the switch when “end” is displayed. Consult a service manual for trouble code descriptions.
SPEED CALIBRATION
The speed calibration is not required unless you have changed out the stock transmission, pulley, or tires.
ADJvST
ADJvST ADJvST
ADJvST Adjust
• Press and release the switch until “AdJvSt” is displayed, then press and hold the switch until “ - ” is displayed.
• Release the switch. The display will show “fast“ or “sLOWX”. Fast will allow you to increase the speedometer reading, slow will
allow you to decrease the speedometer reading.
• Press and release the switch to change, press and hold the switch to continue. The display will change to “CL” and a number
from 0.75 to 1.25. This is the calibration ratio that is applied to the reading that the ECM is providing. 1.10 will be 10% faster,
0.90 will be 10% slower.
Actual speed
----------------------------- x current cal ratio (1.00 by default) = new cal ratio
speedometer reading
• Press and release the switch to change the cal ratio. When the desired cal ratio is shown, press and hold the switch to save it.
vNIT
vNIT vNIT
vNIT Speed unit
• Press and release the switch until “vnit” is displayed, then press and hold the switch until “ - ” is displayed.
• Release the switch. The display will light up the current speed unit (MPH or km/h).
• Press and hold the switch to keep the current unit or press and release the switch to change the unit.
•
Press and hold the switch until “ - ” is displayed to save the setting.
S SET
S SET S SET
S SET Miles to Next Service setup
The service mileage is a countdown mile meter. The service mile display can be disabled or can be set to count down
from 500 – 7500 miles. If the service mileage is enabled and it gets to 0 miles it will display “S -DvE” each time the key is turned
on. If the push button switch is pressed and held while “S -dve“ or “S” and a mileage is displayed, the service miles will be reset to
your preset value.
• Press and release the switch until “S set” is displayed, then press and hold the switch until “ – ” is displayed.
• Release the switch. The current setting will be displayed, “OFF” or a mileage from 500 - 7500.
• Press and release the switch until the desired setting is displayed.
•
Press and hold the switch until “ - ” is displayed to save the setting.