Filter
Top Products
•
4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is
recommended.
5. Remove the screw and aluminum back plate from the new LED assembly.
LED assembly Back plate removed Back plate for ’75-’76 Caprice
(attached to the assembly) (packaged separately)
6. Insert the new LED assembly into the hole where the original bulb and connector were located.
Use caution when feeding the wires through to avoid damaging the wire insulation.
7. Feed the wires through the large hole on the back plate before attaching it to the back side of
the tail light housing. On the plastic ‘75-‘76 Caprice housing make sure to use the back plate
with the three alignment tabs.
MAN#650159b