Filter
Top Products
Speed Sensor
Installation
of the speed sensor is generally straight
then simply tighten the new sensor in place making sure that t
the existing speedometer gear. The sensor will thread directly onto a standard GM transmission speedometer
gear that has 7/8”-18 threads.
Connect the harness until it “clips” into place
harness connector while pressing it
onto the sensor
connector body in only one direction.
Ford Adaptor
Cable (Included in Certain
First,
remove the stock gear from the end of the original speedo
is removed, install it onto the new
Ford adaptor cable
the original attachment screw
, making
transmission. Finally, thread
the new speed sensor onto the
Original
speed sensor removed from
Gear installed on new Ford adaptor
If you are using
an electronic speed sensor
speed output (VSS),
the speed sensor supplied in this kit
directly to the SPD SND
terminal on the
of the speed sensor is generally straight
forward. Remove the cable from the transmission if
then simply tighten the new sensor in place making sure that t
he square drive shaft on the sensor engages into
the existing speedometer gear. The sensor will thread directly onto a standard GM transmission speedometer
Connect the harness until it “clips” into place
. You may need
to depress the silver wire
onto the sensor
to lock it in place.
The harness is indexed to fit the
connector body in only one direction.
Cable (Included in Certain
Model Applications)
remove the stock gear from the end of the original speedo
meter cable or pulse generator. Once the gear
Ford adaptor cable
. Secure the new F
ord adaptor to the trans
, making
certain the gears on the adaptor
correspond with the mating gears on the
the new speed sensor onto the
Ford adaptor cable
.
speed sensor removed from
transmission
Gear and clip removed
Gear installed on new Ford adaptor
New sensor installed on adaptor
an electronic speed sensor
installed in the transmission
or have an
the speed sensor supplied in this kit
will not be used.
Instead, route
terminal on the
control module.
MAN#650311
forward. Remove the cable from the transmission if
present,
he square drive shaft on the sensor engages into
the existing speedometer gear. The sensor will thread directly onto a standard GM transmission speedometer
to depress the silver wire
locking clip on the
The harness is indexed to fit the
meter cable or pulse generator. Once the gear
ord adaptor to the trans
mission using
correspond with the mating gears on the
.
Gear and clip removed
New sensor installed on adaptor
or have an
ECM that provides a vehicle
Instead, route
the speed signal