Filter
Top Products
Diesel Engine Complete Engine
64
Measure the crankshaft end play using a dial indicator.
Crankshaft End Play
mm in
0.131 MIN 0.0052
0.351 MAX 0.0138
Piston, Connecting Rod Assembly - Assemble
CAU
TIO
N
Be careful not to damage the piston or break the
piston rings.
Install the piston rings on the piston using piston ring
tool, Part No. 3823137.
NOTE: The rings must be set with the stamped
mark near the end facing up. The oil ring
(bottom ring) must be set with matching part
of the expander coil and the end gap of the
ring 180 degrees apart.
Install one snap ring on one side of the piston into the
snap ring groove.
NOTE: The stamped “F” mark on the piston and the
match mark (or cast part number) on the
connecting rod must face in the same
direction.
Assemble the piston on the connecting rod by
installing the piston pin.
NOTE: Pistons do not need to be heated prior to
installing the piston pin. However, placing
the piston in hot water prior to installing the
pin will ease the installation
.
00900202
00900223
00900198
00900197