Filter
Top Products
Series TS
Specifications
10 Lift Height in 219 231 243 255 267 279 291 303 315 327 339 351 363
Free Lift (TN)* in 84 84 84 84 84 84 84 84 84 84 84 84 84
Free Lift (TF)** in 83 89 95 101 107 113 119 125 131 137 143 149 155
11 Collapsed Height in 125 131 137 143 149 155 161 167 173 179 185 191 197
12 Extended Height in 261 273 285 297 309 321 333 345 357 369 381 393 405
Mast
10 Lift Height in 375 387 399 411 423 435 447 459 471 483 495 507
Free Lift (TN)* in 84 84 84 84 84 84 84 84 84 84 84 84
Free Lift (TF)** in 161 167 173 179 185 191 197 203 209 215 221 227
11 Collapsed Height in 203 209 215 221 227 233 239 245 251 257 263 269
12 Extended Height in 417 429 441 453 465 477 489 501 513 525 537 549
Mast
* Auxiliary lift only.
** Including auxiliary lift.
Note: Battery removal from left side.
Standard Equipment
1. 72-volt fused electrical system.
2. SCR controlled lift and drive
motors.
3. Electric power steering.
4. Microprocessor controlled.
5. 350-amp battery connector.
6. Emergency power disconnect.
7. Color-coded wiring.
8. Chain slack sensors.
9. Hour meters independently
recording key on, traction,
lift, steer and accessories.
10. Start-up time and run time
diagnostics.
11. Diagnostic history with
optional service terminal.
12. Battery discharge indicator
with lift interrupt.
13. Maximum travel speed
programmed to meet the
application’s specs.
14. Gradual reduction in maxi-
mum travel speed as primary
lift is increased.
15. Swivel seat with height
adjustment.
16. Hinged cab door.
17. Key switch.
18. Horn.
19. Two-speed fan.
20. Cab light.
21. Work lights.
22. Rear view mirror.
23. Flashing light.
24. Storage pockets.
25. Infinite hydraulic control of
raise/lower, traverse and pivot.
26. Manual lowering valve
located in power unit.
27. Solid four-point suspension.
28. Rigid tubular mast.
29. Third mast chain.
30. 2-3/4" diameter battery
rollers.
31. Dual drive units.
32. Four-wheel braking automat-
ically switched to two-wheel
at slower speeds.
Optional Equipment
1. Wire guidance.
2. Rail guidance.
3. End of aisle control system.
4. Extended load handler
lengths and carriage widths.
5. Extended Auxiliary Lifting
heights.
6. Programmable fork height
limits with overrides.
7. Non-marking tires.
8. Power source and mounting
brackets for CRT.
9. Fire extinguisher.
10. Cold conditioning.
11. Additional work lights.
12. Service Terminal.
Series TS
Technical Information