Filter
Top Products
OPERATOR COMPARTMENT
A unique suspension compartment isolates
the operator from the fl oor surface and
from engine vibration, for greater operator
comfort and productivity.
• Comfort seat has built-in lumbar support,
retractable seat belt, lateral restraint sys-
tem, and fore and aft adjustment.
• Hydraulic control levers are positioned for
optimum access and ease of use. Inter-
national symbols on the contoured grips
indicate the function.
• Tilting steering console has small-diameter
steering wheel and electronic instrumen-
tation. Tilt is infi nitely adjustable, with
extended room between the engine cover
and console.
• Wide-open fl oorboard has suspended
brake and inching pedals with ribbed rub-
ber pads for comfort and safety. Integral
accelerator mechanism has a transfer roller
for smooth operation.
• Full-width rubber fl oor mat provides a
large, non-slip surface and reduces noise,
vibration and heat.
• Large, open steps with a traction surface
and a large handgrip provide easy entry
and exit for the operator.
• Standard headlight/turn indicator control
lever is mounted on the steering column
for easy use.
• Full-width overhead guard provides excel-
lent visibility for high stacking and meets
or exceeds ITSDF requirements.
SERVICEABILITY
The engine and transmission can be easily
accessed for daily inspection without the use
of any tools.
• Single-piece, all-steel engine cover and
seat support is fully insulated to reduce
noise and heat transfer.
• Engine cover has gas-fi lled cylinder with
an automatic locking device to assist in
opening and to prevent the cover from
unexpectedly closing.
• Easy-access, easy-operation engine cover
latch is recessed to prevent interference
when entering and exiting the operator
compartment.
• Engine cover is shaped for easy access
into the engine area for maintenance
and service.
COMPLIANCE, APPROVALS AND
ENVIRONMENTAL CONCERNS
Designed for recycling at end of life, with
special attention to materials and con-
struction. Counterweight designed for
breakup during recycling process. Trans-
mission case is recyclable aluminum.
Hamech Lift Trucks meet or exceed
American National Standard Institute, ITSDF
B56.1-Part III Safety Standards for Powered
Industrial Trucks.
Compliant with UL 558 for the appropriate
truck type. Contact your dealer for appli-
cation-specifi c requirements. Contact your
dealer for application-specifi c requirements.
Meets or exceeds current EPA emissions
standards.
TECHNICAL DATA