Filter
Top Products
PROGRAMMABLE OPTION RESET
This system provides a “reset method” to restore all options to FACTORY DEFAULT VALUES as listed in the
“Button #2” column of the programmable option chart on pages 18-19. This can be helpful if you have lost track of
the option settings on your system or when you are moving systems from car to car.
1. Open hood (ground the Blue wire if no hood pin is installed)
2. Turn Key to the ON position
3. Press program / valet button 5 times, after a few seconds the unit will flash the lights 5 times.
4. Push the valet/program button 25 times. Press carefully, do not lose count! You must get a light flash each time
you press the button. If the unit didn’t flash the lights, then the system did not register your press.
5. Press button #2 (Unlock) to reset the options. (Lights should flash twice)
6. Turn Ignition OFF, Close hood (un-ground Blue wire). All features should be set at *DEFAULT values.
PROGRAMMING – TRANSCEIVERS & TRANSMITTERS
MAKE a NOTE of the following transmitter / transceiver compatibilities:
• CS-2011RS Series IV 1-WAY SYSTEM: CS-396 Remotes
• CS-2015FM 2-WAY SYSTEM: CS-399FM LCD Remote
• CS2015FM TW1 Series II 2-WAY SYSTEM: CS-399FM LCD 2-Way remote AND a CS-397 1-Way remote
CS2015FM/TW1 systems will only learn 2-Way LCD Transceiver Remotes and the special 397 1-Way remote. The
CS2011RS IV system will only learn CS-396 or other 1-Way transmitters. When re-learning remotes or adding
remotes, ALL your system’s remotes must be learned at time of programming! These systems allow storage of up
to 4 different remote codes in memory.
1. Open Hood (Ground the Blue wire if no hood pin is installed.)
2. Turn key to the ON position. (Doors will lock if Autolock is programmed)
3. Press Programming button 4 times, then after a few seconds the unit will flash the parking lights 4 times.
4. For CS2011RS systems: Press button #1 (Lock) of the transmitter; For CS-2015FM/TW1 systems: Press Buttons
#1 & 2 together. You should get 2 light flashes indication the unit is waiting for a 2
nd
code, then press the same
combination of button #1 or #1 & #2 of a second transmitter or transceiver, the unit will flash 3 times indicating its
waiting for the 3
rd
code and lights will flash 4 times for 4
th
code. If all 4 codes are learned, the unit will
automatically exit code learning mode, otherwise turn key off and close hood.
DIAGRAM ON NEXT PAGE.
22