Filter
Top Products
of an external relay. This system must be programmed to allow the relay to work as a starter disable.
PASSIVE STARTER DISABLE (Optional)
This RS900 includes a programmable feature to allow the Optional Starter Disable to activate automatically 1 minute
after the ignition is turned off. This programmable feature may provide insurance discounts or meet an insurance
requirement in your providence.
HOOD OPEN SAFETY (Requires grounding hood pin installation)
Prevents the engine being Remote Started when hood is open and will shut OFF the engine if opened during a remote
start. Eliminates risk of injury to someone working under the hood of the vehicle with a properly working hood pin
installed. If Remote Start button is pressed with the hood open, the lights will flash once and the unit will not attempt a
start.
BRAKE PEDAL RESET
Prevents starting or shuts off a remote started vehicle when this circuit is active or activated. Prevents unauthorized
tampering. This circuit shuts the system down immediately when brake pedal is pressed if key is not in ignition and
turned ON.
OEM ALARM INTERFACE
This feature is designed to Disarm and Re-arm Factory equipped security systems in conjunction with remote start and
keyless entry (if needed for your vehicle). This feature will maintain the original integrity and security of your vehicle’s
factory equipped systems before, during, or after timed out or an aborted remote start.
NOTE:
When changing, charging, or jumpstarting the vehicle’s battery we recommend removing the main power fuses located
on the heavy gauge RED wires near the remote start module.
TRANSMITTER PROGRAMMING
TRANSMITTER PROGRAMMING:
Note: All transmitter codes must be learned at time of programming!! The RS900 allows storage of up to 4
different transmitter codes.
1. Open Hood.
2. Turn key to the ON position. (Doors will lock if Autolock is programmed)
3. Press Programming button 4 times, then after a few seconds the unit flashes the parking lights 4 times.
4. Press button #1 of the transmitter to be coded. You should get 2 light flashes indicating the unit is waiting for a 2
nd
code, then press button #1 of a second transmitter, the unit will flash 3 times indicating its waiting for the 3
rd
code