Crimestopper Security Products RS800 Series II Automobile Alarm User Manual


  Open as PDF
of 4
 
OPERATING THE REMOTE TRANSMITTER
The transmitter supplied with this RS800 system has (2) buttons / channels.
#1
#2
START
LOCK/
REMOTE
START
UNLOCK
C
RIME
S
TOPPER
REMOTE ENGINE CONTROL
REMOTE ENGINE STARTING - SUCCESSFUL START:
1) Press and release the remote start button.
2) Parking lights flash once, then turn ON along with the IGN/ACC circuits
3) After 6 seconds Starter Motor engages. (Parking lights and Acc circuits turn off while cranking.)
4) Engine Starts and Runs. Parking Lights and Acc turn back on, Doors Lock.
5) Engine will remain running for programmed run time or until reset with Brake pedal. If needed, the engine can be
turned off with remote transmitter or for RS801 model, activating the Green Start input wire again.
AFTER
IGN
6
STARTER
THEN
FLASH 1X
SOLID
SOLID
SEC.
START
NOTE:
When using the optional
Starter Disable feature without
power door locks, be certain to
install the supplied L.E.D. which
will be your only
indication that
the Starter Disable is active. You
must press the UNLOCK button on
the transmitter if the L.E.D. is
flashing or the vehicle will not
start.
 previous next