Filter
Top Products
22
TRANSMITTER PROGRAMMING
Transmitter Programming: (Excludes EZ-30DP model without remotes)
Notes: Remote Transmitters/Transceivers come pre-programmed from the Factory. When re-learning remotes or
adding remotes, ALL your system’s remote codes must be learned at time of programming!! These systems allow
storage of up to 4 different remote codes in memory. The EZ-64TW1/74TW2/84FM systems include both a 1-way
remote transmitter and an LED or LCD remote. The “Sidekick” transmitters for the 2-way systems are a special model
that is not compatible with standard EZ-31DP/33DP/34DP remotes. EZ-31DP/33DP/34DP and EZ-64TW1/74TW2/84FM
remotes are not interchangeable.
1. Open hood (ground the Gray hood pin wire if no hood pin is installed.)
2. Turn key to the ON position. (Do not start vehicle) Pink wire must be connected!
3. Press Program/Valet button 4 times. Wait for the unit to flash the parking lights and/or honk horn exactly 4 times.
4. EZ-30DP/31DP/33DP/34DP: Press Button #1 (Lock) or Press Start(EZ-31DP ) of the transmitter to be learned. EZ-
64TW1/74TW2/84FM: Both the Lock & Unlock buttons must be pressed. You should get 2 light flashes and 2 horn
honks indicating the code-learn. Now the unit is waiting for a 2
nd
code, so repeat this step as needed with up to 3
additional remotes. The unit will flash the lights in succession after each code learned for up to 4 codes. (3 flashes
for the 2
nd
code, 4 flashes for the 3
rd
code and 0 for 4
th
code.) If all 4 codes are learned, the unit will automatically exit
code learning mode, otherwise turn key OFF and close the hood.
IGN
OFF
WAIT FOR
4 FLASHES
PRESS 4X's
FLASH 2, 3, or 4 X's
(GRAY WIRE GROUNDED)
EZ-64TW1/74TW2
EZ-33/34DP
IGN
OFF
PRESS TOGETHER
LOCK &
UNLOCK
PRESS
LOCK ONLY
(2-Way systems only)
COMPLETE
1-Way systems
EZ-31DP (USE START BUTTON)