Filter
Top Products
3
2
-
WAY LED PAGING REMOTE
PAGER / REMOTE TRANSCEIVER:
The hand-held remote transceiver is used to send and receive information from
the vehicle. The Control Module transmits confirmation signals from the vehicle to
your pager. Your range will vary depending on location, terrain, and local RF
noise/interference. This system is not guaranteed to page you if you are behind
concrete walls, underground, in a large structure, or in an area with high levels of
electronic interference. Handle the pager/remote with care. For more on range,
see “Range Questions” on page 18.
OPERATION:
Button Functions Button Options Buttons Functions
Button Options
Lock Doors & Arm System Press and Hold for 3
seconds
Activate “Panic” feature
Aux#3 Press Button #1 and #4 at the
same time
Unlock Doors & Disarm
System
Press twice for second door
unlock
Aux #4 Press Button #3 and #4 at the
same time.
Trunk Release (Aux # 1) Press and Release for Aux
#1
Car Jack
(See page 14)
Press and Hold Button #1 and #3
at the same time for 2 seconds.
Aux #2 Press and Hold Button #2
and #3 at the same time for
3 seconds. (Aux #2)
Silent
Arm/Disarm
Press Button #2 and #4 at the
same time.
Start or Stop engine Press and Hold for 3
seconds
Sensor Disable
Valet mode
Press within 3 seconds of arming to disable
sensor input
When Disarmed Press and Hold for 3
seconds to go into Valet mode. Release,
press and hold again for 3 sec. to enter
Valet Park.
Press and hold for 5 seconds to switch to vehicle #2.
Side Button
2-car operation (Side Button)
(Change from Car 1 to Car
2)
Press and release to show the previous status.
UNLOCK
LOCK
STARTTRUNK
#1
#2
#3
ENGINE
POP
VEHICLE
2nd
#5
#4