Filter
Top Products
4
OPERATION
FIG. 3
KNOW YOUR JACK
Compare Fig. 3 illustration with your jack
BEFORE operation to become familiar with
the location of various jack components.
BEFORE USE
•Read the operator's manual completely
and familiarize yourself thoroughly with the
product, its components and recognize the
hazards associated with its use.
•Occasionally during shipment and/or
handling air can get trapped in the system,
which can interfere with the jacks lifting
performance.
• It is recommended to cycle the jack a few
times without applying load:
•Close release valve by turning the jack
handle clockwise until tight.
• Pump the handle until the jack saddle
reaches its maximum height.
• Open release valve by turning jack handle
counterclockwise, but no more than 1/2
full turn. Allow the saddle to reach its
lowest position.
• Repeat the above procedure a few times.
•To release air from the hydraulic system:
•Open the release valve by turning the jack
handle counterclockwise, but never by
more than 1/2 full turn.
• Remove the oil filler plug from the cylinder.
(see Fig. 4)
•Rapidly pump jack handle through several
full strokes.
• Reinstall the oil filler plug into the cylinder
again and jack is now ready to use.
Jack Handle
Handle
Socket
Rear Caster
Front Wheel
Lifting Arm
Oil Filler Plug
(Not Shown, on Reservoir)
Saddle
Release Valve
SPECIFICATIONS
Rated Capacity: 3 Ton / 6000 Lbs
Jack Dimensions: 25” x 13 7/16” x 6 7/16”
Lifting Range: 5 1/2” - 19”
(140mm - 483mm)
Oil Capacity: 150 c.c.
Net Weight: 80.7 Lbs