Filter
Top Products
4
Quick Reference
Valet Mode
When servicing or loaning your vehicle to others, the CompuStar Pro system should be placed in Valet
mode. Valet mode prevents the system from remote starting and disables all alarm functions.
IMPORTANT: While in Valet mode the CompuStar will still lock and unlock power lock systems.
The system can be put into valet one of two ways;
1. You can put the system into valet by turning the ignition key “on” and then “off” five
times within 7 seconds. The parking lights will flash once to confirm the system is in
valet mode. Shortly after the first flash, the parking lights will flash twice.
2. (Optional Feature) If your system is set up for a secure valet option, you will not be able to put the
system into valet until the proper code has been entered with the secure valet switch.
Remote Maintenance – Battery Replacement
The only regular maintenance this system requires is remote control battery replacement.
No programming is required when replacing the battery.
One-Way Remote: Pro 1BAMR
First, remove the small Phillips screw located on the back of the remote. Once the screw has been
removed, gently pull the remote apart being careful to not touch the circuit board. The P1BAMR requires
two CR2016 batteries. These specialty batteries can be purchased from your local CompuStar dealer or
an electronics store.
1 Button Remote Functions
Button Duration
Additional
Programming
Required
Function / Description
1.0
second
no Lock/Arm. Tap again to Unlock/Disarm your vehicle
3.5
seconds
no Activates the remote start. Repeat and remote start will shut off.
General System Functions
The remote transmitter functions have been predetermined and programmed from the factory. The single
button configuration allows for keyless entry and/or remote start functionality. Although other CompuStar
PRO systems have numerous button functions and capabilities, please keep in mind that your system
has the option for future upgradeability to a 2-way system.
Sending Commands
When in range, and the button has been pressed, the remote bright blue LED will illuminate and vehicle’s
parking lights will flash. For example, to send a remote start command from the P1BAMR, hold down the
single button for 3.5 seconds. The remote bright blue LED will come on solid and then flash.