Filter
Top Products
Aux Button (1.5 Sec.) – Holding this button for 1.5 seconds will activate an auxiliary trigger on your
vehicle. This is an optional function and could be used to unlock your trunk or open sliding doors.
___________________________________________________________________________________________________________________
V
ALET
M
ODE
Valet Mode bypasses the functions of your remote starter. It is used in the event you bring your vehicle in for service, loan your vehicle to
someone, or if you have your vehicle parked by valet service. Valet Mode is used as a precaution so there is no accidental activation of the
remote start.
To place your system into Valet Mode you must turn the Ignition On and Off for 5 times within 7 seconds with key. When the parking lights
flash once, pauses and then flashes twice, your system is now in Valet Mode. Please follow this diagram below:
___________________________________________________________________________________________________________________
D
IAGNOSTIC
M
ESSAGES
1. Whenever the system fails to remote start, the vehicle provides you with diagnostic error messages: # of times parking lights flash. The
vehicle will first flash the parking lights 3 times followed by the remote start error.
Number of Parking
Light Flashes
Remote Start Error
1 Motor running
2 Key in ignition on position
3 Door open (manual transmission only)
4 Trunk open
5 Foot brake on
6 Hood open
7 Reservation off (manual transmission only)
8
No tach signal or voltage sensing failure
(please see your CompuStar installer)
2. Depending on the vehicle, it may be possible that the factory remote may not operate while the vehicle is remote started. It is not an
error the CompuStar. It is a function of the vehicle disabling factory features while the car is running.
___________________________________________________________________________________________________________________
M
ANUAL
T
RANSMISSION
V
EHICLES
To use the remote-start function on a manual transmission vehicle, you must first set Reservation Mode. Reservation mode sets the vehicle up
to safely start the next time you use the remote-start. To set Reservation Mode, follow these steps:
1. Completely stop the vehicle and put it in NEUTRAL.
2. Set the emergency brake and remove your foot from the foot brake.
3. A few seconds later you should hear a “click”.
4. Turn the key off and remove it from the ignition. The vehicle will stay running.
5. Exit the vehicle and close the door.
6. The vehicle will shut off, the system will arm, and the doors will lock.
Reservation Mode has now been set. The following actions will cancel Reservation Mode; opening the hood, doors, or trunk, turning on the
ignition, releasing the emergency brake, turning on the ignition, or triggering the alarm. If reservation mode is cancelled, you will need to get in
the vehicle and repeat the setup process.