CompuSTAR CM1000A Automobile Alarm User Manual


 
2019
No.7 Black/White : Negative Input for Optional Sensor
When installing additional sensors, use this wire as the input wire to the alarm
module for those sensors. When connecting more than one sensor to any input
wire, you must diode isolate the output wires of each sensor. Otherwise, they
could back feed into each other, causing false alarms or sensor damage.
1
2
3
Door Lock/Unlock Pulse Duration
Application of Pre-wired Kill Relay
Door Open Parking Light Indicator
0.8 Sec
Starter Kill
Disabled
4 Sec
Anti-jacking
(IG-kill)
Enabled
Features
(Factory Default)
(Optional Setting)
No. 1 Black : L.E.D. Ground
No. 2 Black / White : L.E.D. 3v Positive
When installing the antenna wire, please take care to not excessively bend or
twist it. Excessive or sharp bending or severe twisting can be the cause of
inoperability or range issues.
1. Door Lock/Unlock Pulse Duration
This option determines the output duration of the lock and unlock pulses
Some Vehicles do not respond to short lock/unlock pulses.
2. Application of Pre-wired Kill Relay
This option requires that the starter kill relay be installed in the ignition circuit,
rather than into the starter circuit. With this option turned on, Panic mode will
become Anti-Jacking mode. If Anti-Jacking is activated while the vehicle is
running with the key in the ignition, the siren will sound for 30 seconds.
After 30 seconds the system will break the ignition circuit, therby disabling the
vehicle. The siren will continue to play for 1 more minute. With this option
turned off, when Panic mode is activated, the system will arm, activate the
starter kill, and play the siren for 1.5 minutes.
3. Door Open Parking Light Indicator
With this option enabled, the parking lights will flash if a door is left open
while the vehicle is being armed. This serves as a warning that all of the
doors have not been closed.
Option Menu
No. 1 Black : Shock Sensor Ground
No. 2 White : 2nd Stage Shock Sensor Input
No. 3 Red : Shock Sensor 12v Positive
No. 4 Yellow : 1st Stage Shock Sensor Input
CON 5
CON 4
Antenna
4
30 sec Passive Relock
Disabled
Enabled
5
Double Pulse Unlock
Disabled
Enabled