Filter
Top Products
By Firstech, LLC 22 23 By Firstech, LLC
p@Z@R@w@T@b@rZ
STEP 1:
Activate Valet/Programming mode by manually turning the ignition key on and off (between the Acc & On positions) five times within 7 seconds.
The vehicle’s parking lights will flash once with the successful completion of this step.
STEP 2:
Within 2 seconds after cycling the ignition for the 5th time, press button (I) or Lock on 2 way remotes or the (lock) button on 1 way
remotes for 0.5 second. The parking lights will flash once to confirm the transmitter has been coded.
Exiting Programming:
Programming is a timed sequence. The parking lights will flash twice signaling the end of
programming mode.
Programming Multiple Remotes:
After the confirmation flash given in step 2, code additional remotes by
pressing button (I) or Lock on 2 way remotes or the (lock) button on 1 way remotes. The parking lights will
flash once confirming each additional remote. All systems (except the 2WSSR-PRO), can recognize up to three
remotes.
IMPORTANT:
Every Firstech remote must be coded to the system prior to performing any operations. All remotes must be coded at the same time.
Remote Coding / Programming Routine (S)
If the remote start fails to start the vehicle, the parking lights will flash three times immediately. Following those three flashes the parking lights will flash
again corresponding to the error table.
Remote Start Error Diagnostic
We recommend that you do not attempt any repairs on your remote starter. Contact your dealer or call us directly.
Number of Parking Light Flashes Remote Start Error
1 Motor running
2 Key in ignition on position
3 Door open (manual transmission only)
4 Trunk open
5 Foot brake on
6 Hood open
7 Reservation off (manual transmission only)
8 Tach or voltage sensing failure