Filter
Top Products
7 By Firstech, LLC By Firstech, LLC 6
Quick Reference
The only regular maintenance this system requires is remote control battery replacement. No programming is required when replacing the battery.
Two Way Remotes:
First, remove the small Phillips screw located on the back of the remote. Once the screw has been removed, gently pull the remote apart taking care to not damage the
circuit board. Your battery size should be listed on the battery. (Battery size: CR2450)
IMPORTANT: Be sure to observe correct polarity when installing the battery.
One Way Remotes:
First, remove the small Phillips screw located on the back of the remote. Once the screw has been removed, gently pull the remote apart taking care to not damage
the circuit board. Your battery size should be listed on the battery. Replacements can be purchased from your local Firstech dealer or an electronics store.
r@mMb@r
Quick Reference
R@w@r@b@f
Button(s) Duration Function LED LED 2nd Car Mode Chirp(s)
0.5 second Locks doors and/or arms alarm. Amber Red Once
3.5 seconds Panic/vehicle locater (flashes vehicle’s Green and Red Green and Red N/A
parking lights and sounds siren and horn).
0.5 second Unlocks doors and/or disarms alarm. Amber Red Twice
0.5 second Aux 1. Triggers the auxiliary 1 output (most Amber Red Once
commonly used for rear defrost or window roll-down).
2.5 seconds Trunk release. Triggers the trunk release output and Solid Amber then Solid Red then Flash Red Twice
opens the vehicle’s trunk. Flash Amber
0.5 second Aux 2. Triggers the auxiliary 2 output (most commonly Amber Red Once
used for rear defrost or window roll-down).
2.5 seconds Activates the remote start. Repeat and remote start Solid Amber then Solid Red then Flash Red Once On /
will shut off. Will activate Stop and Go Mode if held Flash Amber Twice Off
when vehicle is running with the key.
0.5 second Turns siren chirps on/off (Note: With the siren chirps off, Amber Red Once On /
it will still sound in the event the alarm is triggered). Twice Off
2.5 seconds Option programming menu 1 - Installers Only. Solid Amber then Solid Red then Flash Red Once
Flash Amber