Code Alarm CSI-200 Automobile Alarm User Manual


 
128-
7 of 8
1. Turn the ignition key on then off.
2. Within 10 seconds, press and release the valet push button switch three times.
3. If the chirps were on before you started, then you will hear 2 chirps indicating they have
been turned off.
If the chirps were off before you started, then you will hear one chirp indicating they have
been turned on.
NOTE: Whenever the chirps are by - passed, the 4 chirp intrusion indicator and 4 chirp
defective zone indicator will always operate. Since these are important warnings to
you that something has happened, they cannot be eliminated.
REMOTE PANIC OPERATION
The Asterisk button on your keychain transmitter also functions as a panic switch for use
in emergency situations. To use remote panic,
1. Press and hold this button (*) on the keychain transmitter for 3 or more seconds. The
alarm will immediately sound.
2. To stop the alarm, press and hold the Asterisk button again for 3 seconds. If the button is
not pressed, the alarm will automatically stop after 30 seconds. Also if any transmitter
button other than the Asterisk button is pressed and released, the Panic mode will be
turned off immediately. The normal function of this transmitter button will be suspended
during the Panic sounding period.
3. During the panic mode, the Lock and Unlock buttons can be used to lock and unlock the
doors, (if the Starter Inhibit Feature is installed), once the unlock/disarm button is pressed,
the vehicle's starter inhibit device, (where installed) will be disabled allowing the vehicle
to start.
NOTE: While in the Panic mode, pressing and releasing the Lock or Unlock buttons will, if the
option is installed, lock and unlock the doors respectively. While in the panic mode,
anytime the Unlock button is pressed, the panic feature will continue for the allotted
30 seconds, however, the security system will be disarmed allowing the vehicle to
start.
ADDITIONAL REMOTE FUNCTION ( CHANNEL 3 )
This security system has an additional features that can be connected to a number of
different optional accessories. The most common is the trunk release where so equipped.
Remote Trunk Release
Operation of the optional accessory can be controlled by pressing and holding the Trunk
button or the Trunk button on the keychain transmitter for four seconds.
ALTERNATE OUTPUT:
This system is designed with an additional output that responds when the programmed
transmitter button is presed two times in succession. The intent of this priority output is for
use with an upgrade "Remote Start Module", however it can be used to operate any other
option that may have been added to your vehicle. Check with your inbstallation center to see
if any options have been added that may be controlled by this output, and how it is ac-
cessed.
IGNITION CONTROLLED LOCK / UNLOCK (Unlock Drivers Only, or Unlock All Doors)
Your security system has a selectable safety feature that allows the vehicle doors to lock
when the ignition switch is turned on, (Providing all doors are closed), and to unlock the
doors when the ignition switch is turned off. In addition, the unlocking of the doors is further
selectable, in a two step unlock configuration, to unlock only the drivers door or all doors.
Page 7