Code Alarm CA 411 Remote Starter User Manual


 
ADJUSTING THE START TIMER FROM 2 TO 4 HOURS:
The SAFETY (Red Handled ) CONTROL SWITCH also allows you to select be-
tween automatic 2 hour start or 4 hour start when using the automatic start timer
mode. The factory preset start up time for this mode is every 4 hours. To select
between 2 or 4 hour start timer:
1. Begin with the saftey control switch in the ON position.
2. Turn the ignition switch ON then OFF.
3. Within 10 seconds, move the control switch OFF,ON,OFF,ON(2 switch cycles)
to select a 2 hour start timer. After 10 seconds expire, the parking lights will
flash 2 times confirming that the 2 hour start cycle is set. Or, within 10 seconds
move the control switch OFF,ON,OFF,ON,OFF,ON,OFF,ON (4 switch cycles) to
select a 4 hour start timer. The parking lights will flash 4 times confirming that the
4 hour start timer is set.
CANCELING THE AUTOMATIC START TIMER:
To cancel the automatic start timer do one of the following:
1. Start the vehicle using the ignition key and depress the brake pedal.
2. Remote start & stop the vehicle using your transmitter.
2007 Code Systems, Inc
FUNCTION SETTING CHART
To be completed by installer
Lights ON Pulse
Run Time 10 Min. 15 Min.